Chevy Check Engine Light Stay On | Troubleshooting Guide

In this guide, we go over common problems that can trigger Chevrolet check engine light to come on, a common problem and how to diagnose it yourself. 

What does Chevy Check Engine Light Mean? 

chevrolet check engine light on

When your Chevrolet check engine light stays on it means that the On Board Diagnositc (OBD) system has detected a problem with the engine, emission system or transmission. A fault code is stored the Engine Control Unit (ECU). 

Chevy check engine light should only on for a few seconds when you turn on the ignition and should turn off once the engine starts. If your Chevy check engine light stays on is flashing get the vehicle diagnosed as possible. 

Chevrolet check engine light may also be referred to as Malfunction Indicator Lamp.

Symptoms

chevy engine car shakes and check engine light on

Common symptoms include:

  • Engine shaking
  • Poor throttle response
  • A decrease in fuel economy
  • Engine misfire
  • Difficult to accelerate or going uphill
  • Engine shakes or excessive vibrations
  • Car won't stay running
  • Check engine flashing

Chevy check engine light may be on, with no performance symptoms. Even if there are no symptoms it is important to read the fault codes to find out why CEL is on.

Common Problems

Loose gas cap triggers chevy check engine light

Common problem that triggers Chevy check engine light to stay on include: 

  • Loose gas cap / damaged seal
  • Faulty Mass Air Flow (MAF) sensor
  • Spark Plugs
  • Faulty ignition coil
  • Bad oxygen (O2) sensor
  • Dirty fuel injector
  • Bad fuel filter or pump
  • Catalytic converter
  • EVAP leak

First, check the gas cap and make sure it is on tight. If the light doesn't reset within the next two to three days, proceded to read the fault codes. 

How to Diagnose Chevrolet Check Engine Light

Follow the instructions below to read Chevrolet service engine light codes. For this procedure you will need an OBD-II scanner

  1. Locate diagnostic port under the dashboard of your Chevrolet on the driver's side. This is a 16-pin port and all 1996 and newer Chevrolet vehicles have this port.Plug in your OBD2 scanner or Bluetooth adapter into the port. Chevrolet  Check Engine Light ON Troulbeshooting
  2. Turn ignition ON, key in position II. All Chevrolet dashboard lights will turn on but do not start the engine. If your Chevrolet has Start/Stop button you will need to press the START button without pressing the brakes. How to diagnose Chevrolet  check engine light service engine soon Spark, Sonic, Bolt, Volt, Cruze, Malibu, Impala, Camaro, Corvette, City Express, Trax, Equinox, Traverse, Tahoe, Suburban, Colorado, Silverado, Sonic, Blazer, Astro, HHR, Uplander, Avalanche etc.
  3. Allow your OBD2 scanner to turn on and connect to your Chevrolet Engine Control Unit (ECU). This step can take up to one minute. Check Engine Light On Chevrolet
  4. Read Chevrolet check engine light codes from the Engine Control Unit (ECU) using an OBD-II scanner.
  5. Once you have retrieved the codes, write them down. Research the codes and fix the underlying problem, you can come back to reset Chevrolet check engine light. erase Chevrolet  check engine light Spark, Sonic, Bolt, Volt, Cruze, Malibu, Impala, Camaro, Corvette, City Express, Trax, Equinox, Traverse, Tahoe, Suburban, Colorado, Silverado, Sonic, Blazer, Astro, HHR, Uplander, Avalanche etc.

The fault codes are just the starting point. Research every present code and common problem. Don't replace parts based on the fault code only. Get the opinion of a professional mechanic before replacing any parts. 

Chevrolet
Visitor

My Chevrolet Cruze 2012 when engine is running engine light still on and is coming to the mechanical

  • Log in or register to post comments