How to Replace Ford Focus Coolant Overflow Reservoir

Guide

In this guide, you will find instructions on how to change the coolant overflow tank on Ford Focus vehicles.

Read More

Ford Focus Water Pump Replacement

Guide

In this guide, you will find step-by-step instructions on how to change the water pump on the Ford four-cylinder engine known as Duratec FFV 2.0-liter Ti-VCT inline 4.

Read More

Focus 2011 Steering Angle Sensor data access

15 Nov 2019 •
Hi, I have a Steering Wheel Module from a 2011 Ford Focus and I need to access the data from the Steering Angle Sensor. I have already got as far as connecting to the LIN bus for the stalks and that works fine, but I also need to get steering angle data. I beleive this data is available on a CAN bus on that module, but I can't find any info about what pins I need to tap into on the SAS connector (I don't have the original harness from the car that the module came from). Can anybody help out with a pinout for the SAS module? Thanks. Doug.

What wrong with my breaks

4 Oct 2019 •
My break petal almost falls to the floor when I apply pressure to it and makes a wooshing, wind blowing, sound. The petal won't tighten up either. But with the car turned off the break petal will tighten up when pumped, but car turned on nothing but the petal is going to the floor. Why? 

Ford Focus Oil Change Light

23 Jul 2019 •
So yesterday I am driving my Ford Focus(1 litre ecoboost 125hp) and all of a sudden the oil change light starts blinking. I stop the car immediately just to check if a quick start and stop of the car will fix the light or not and it doesn't. So I go out and wait for the engine to cool to see if there is enough oil in it. I clean the dipstick and put it back in and then take it out again and to my surprise-the oil level is fine almost near the maximum. Now it has been some time since I last did an oil change- perhaps around 13,000km which is probably a lot but I totally forgot to do it :D.