I have a 2017 Mercedes CLA250 that has gone into limp mode and check engine light is on. I have already ran diagnostic scan and got code P0234. I believe it is the boost sensor, MAF sensor, or MAP sensor. Problem is, I do not know where any of these are located. Does anyone have a clear picture of where each of these sensors are located?
Hello. I have a problem with my MB Cla 220 CDI 2013y automatic transimission. When car is standing and i put it in D or R it starts to shake. I have buy in MB and changeboth motor holders but problem is still here. In N or P is better and car is not shaking so much. But when i put in D or R i feel push and car is shaking. When i start to drive car everything is ok again. Doesnt metter if car is cold or warm, all the time is shaking in D and R. What do you think what can cause this problems?
I have a 2018 Mercedes CLA 250. It doesn't have apple car play or android auto integration to my surprise, BUT it HAS the Carplay USB port inside the armrest compartment. (go figure!)
My guess it is missing the software piece to get it to work..
I saw the post:
Then looked at the MB VIN Decoder for the benz and it shows:
My 2017 Mercedes Benz cla 250 is showing to check washer fluid so i filled it also no fluid was coming out.. after i filled I u it still showed check washer fluid.. and it still won't dispense... I checked to make sure the pump was working and it is so what could be the problem.. can you help me in trouble shooting this issue?